Preparation:

 This is everything that is included with your Small Training Kit.

 You should not require any additional tools for the installation.

 This installation is meant for a helicopter equiped with landing skids.

 This training kit will not fit a helicopter using wheeled landing gears without some modifcations.

 Please note the included black plastic rod holders (x4) shown here are optional.

 You can choose to use zip-ties (not supplied) to secure the rod holders onto the landing skids and attach the rods to the holders.

 Or you may choose to zip-tie (zip-ties not supplied with kit) the rods directly to the landing skids themselves without using the rod holders.

 The following instructions in this guide will cover the steps for attachment directly to the landing skids.

 Insert one of the supplied rubber stoppers onto one of the supplied rods.

 Next slide one of the plastic spheres onto the rod, and then attach one more stopper to keep it in place.

 Repeat this process for all four rods and plastic spheres.

 Now connect all four rods with the spheres attached to the plastic central hub as shown.

 You will want them to form an "X" shape as shown in this photo, please make sure all rods are fully inserted all the way in.

 Now we are ready to mount the helicopter to the training kit.

 Run the rods through across the landing skids as shown here.

 Position the training gear rods as shown here.

 Your helicopter and training kit should be lined up like this.

 Here is a view from the side, at this time the only thing left to do is to secure the rods to the landing skid and landing struts, we recommend zip ties for this purpose, but you are welcome to use other means as long as it is secured in place.

 After that final step, your kit is fully installed and ready to use.