Engineered for effortless use in simple lighting installations in your model aircraft, this unit can control lights in various modes, including solid state, flashing, strobe, and even afterburner rings.

INITIAL INSTALLATION AND SETUP:

1. Configure two channels on your radio with the desired switches or sliders to control each channel (one for lights and one for the afterburner/throttle, if applicable).

2. Set the end point travel of both channels to -100% and +100%.

3. Utilize the two leads from the Navigation Light Controller for Radio inputs for Lights and Throttle, and connect them to the corresponding receiver channels configured in Step 1.

4. Connect the LEDs to the corresponding outputs on the Navigation Light Controller, selecting which lights should remain on permanently, which should flash, strobe, or activate the afterburner.

SEQUENCES:

Three different sequences are available for the main lights, while the afterburner is always linked to the throttle position.

MODE A:

When power is supplied to the unit, it defaults to this mode: power is provided to all LEDs, resulting in the 'No Flash' (solid light) being on, the strobe being on, and the flash being on.

MODE B:

When the switch button is pressed or the radio channel signal is changed, Mode B is activated. In this mode, the 'No Flash' (solid light) is turned off, while the strobe and flash remain on.

MODE C:

If the switch button is pressed again or the radio channel signal is changed again, Mode C is activated. In this mode, all lights are turned off.

• Controls solid lights, flashing lights, strobe lights and two afterburners
• Can be controlled from receiver or on board button
• Second receiver channel for throttle to control afterburner

• 1x LED Navigation Light Controller