Pilot-RC LED Navigation Light Controller designed to operate as easily as possible for simple lighting installations in your model aircraft. This particular unit is able to control lights either in a solid state, flashing, strobe and even afterburner rings.

• Operating voltage: 7.4v – 8.4v (Direct from 2s Lipo battery)
• Low voltage cut off: Solid lights and afterburner auto off if battery drops below 7.2v. Complete auto off if battery then drops below 7.0v
• Controls solid lights, flashing lights, strobe lights and two afterburners
• Can be controlled from receiver or on board button
• Second receiver channel for throttle to control afterburner

1. Setup two channels on your radio with the desired switches/sliders to control each channel (one for lights and one for the afterburner/throttle if used)
2. Set both channels end point travels to -100% and +100%
3. Use from the Navigation Light Controller the two leads for Radio inputs for Lights and Throttle, and connect to the corresponding receiver channels set up in step 1
4. Connect the LED to the Navigation Light Controllers corresponding outputs, selecting which lights should be on permanently, which flash, strobe or the afterburner

• Do not exceed the maximum voltage of 8.4v or equivalent 2s Lipo

A total of three separate sequences are available for the main lights, with the Afterburner being always linked to the throttle position