Available Package Options
This is the new Aeroplus RC Ti Trainer PNP! Pre-installed Futaba full size servos , 5050-500KV brushless outrunner motor, 80 AMP ESC all installed! No glue is needed for the initial build! Just Screw on the landing gear, screw on the tail section and install your receiver! BIG indestructible wheels gives you a wide choice of runway options! Super smooth flying character gices this Ti Trainer a relaxing flight feel. When you are ready, Ti Trainer can turn up the performance and perform many 3D maneuvers! Beautiful covering and all laser cut wood with precision ball end pushrods and aluminum control surface arms. Wings are using a care free plug system and a single wing bolt thumb screw for each side. Battery can range from a 6s 3000 to 4500. 3300mAh is the best size for sport flying and light 3D. Tons of vertical power and just super fun to fly! Pushrods are installed and centered right out of the box! This Ti trainer can be flight ready from out of the box to flying in less than 15 minutes!
Introducing the All New AeroPlus RC All Wood Titanium Trainer
Flying Skill Level:Excellent for beginners and pilots of all skill levels. No previous experience necessary. Flight simulator or experienced pilot supervision recommended for beginner pilots.
Build Level:Minimal airplane assembly required. Less than 1 hour to begin flying (excluding battery charging time). Please dry fit and test all electronics before gluing components and assembly.
Maintenance Level:After every 10 flights and before and after storing airplane, please check all control surface horns and tighten the screws on surface horns if needed. Check the control pushrod clevises to insure no cracks are visible and no clevis is loose. Make sure transmitter batteries are always fresh and or in new condition.
This packaging option indicates what comes included and does not mean a completely assembled item. Most on-board electronic components are pre-assembled out of the box though some assembly is still required. This packaging option includes a radio system, Battery and charger, unless noted otherwise.
The main difference is what is included in the package. Since there are no set parameters for packaging options in this hobby, different manufacturers may vary their definitions of what is included.
ARF indicates that all the foam pieces along with the crucial components of aesthetic appearance are included in the package. Some on-board electronics may be included with a KIT such as the electric retracts and will be noted on the specifications of the model. Note that this packaging option is recommended for advanced individuals with knowledge in customizing their onboard electronic components or for those not intending to fly this model.
PNP indicates that all the foam pieces along with the crucial components of aesthetic appearance and electronic components are included with the exception of the battery, balance charger, and radio system (transmitter and receiver). Most on-board electronics are pre-installed by the manufacturer. Note that this packaging option is recommended for those who already own a radio system, battery and balance charger.
RTF includes all the foam pieces along with the crucial components of aesthetic appearance, electronic components, battery, balance charger and radio system unless noted otherwise. Most on-board electronics are pre-installed by the manufacturer. Note that this packaging option is recommended for beginners or first-time pilots. Be aware of balance charger accessories that are not included (wall adapters usually sold separately). Advanced models with the RTF option may or may not come with a battery or charger. Please read the ‘Package Includes’ area carefully under the item’s for clarification of what is included with the package.
Copyright © Banana Hobby, All rights reserved. All prices and specifications are subject to change without notice. Banana Hobby is not responsible for typographical errors. All typographical errors are subject to correction.